TURNING SERIES
CK-Series CNC Lathes
CK-46 slant-bed CNC lathes: Meehanite casting with secondary annealing, 5,000 rpm A2-5 spindle, for high-precision medium parts in volume.
View detailsTURNING SERIES
A power turret lathe is the machine you buy when the cut is heavy and the part is hard. The turret indexes under servo control, the base is cast in resin sand, and the spindle is supported by precision bearings — three things that decide whether the machine still holds size after a thousand parts.
Hard material and a large depth of cut put force into the bed. A resin-sand cast base resists that force with less deformation, so the machine keeps its accuracy through a heavy-cutting cycle instead of drifting as the casting flexes.
Figures are as published for this model — final values are confirmed on the quotation.
| Max. swing over turret | Ø450 mm |
|---|---|
| Max. bar diameter | Ø52 mm |
| Spindle through hole | Ø66 mm (material through Ø52 mm) |
| Spindle type | A2-6 |
| Spindle taper | MT-5 |
| Max. spindle speed | 4,000 rpm |
| Spindle motor power | 11 kW |
| X / Z rapid traverse | 24 m/min |
| X / Z servo motor power | 2.4 kW |
| Chuck and rotary cylinder | 8 inch |
| Repeat positioning accuracy (X / Z) | ±0.003 mm |
| Positioning accuracy (X / Z) | ±0.003 mm |
Hardened shafts, hydraulic fittings, bearing rings, pins, bushings and valve bodies — parts where the cut is heavy and the diameter has to stay round.
Send the material, the hardness and the depth of cut you run, and we will confirm the spindle, the turret and the tooling that holds size on it.
Tooling & configuration
Hard material and heavy depth of cut — the tooling has to survive the force, not just the size.
Not sure what you need? Send the part drawing, the material and the batch size — we return a tooling list and a configured machine price, both on the same quotation.
QUOTE REQUEST
CP-Series Power Turret Lathes
INDUSTRIES
Parts we build these machines around, quoted from your drawing.
Brackets, housings and drivetrain parts machined in one setup.
Aluminium frames, middle plates and heat sinks with fine surface requirements.
Battery trays and module structures with long, flat surfaces to hold tolerance.
Core and cavity work where contour accuracy drives the final finish.
Compressor housings, motor casings and steel panels produced in volume.
Hinges, handles and fasteners machined from bar stock, finished evenly.
HOW WE WORK
Six steps, each with a document you can hold us to.

A drawing, a 3D file or a sample part is enough to start.

Our engineers match the part to the right machine family and quote it.

Spindle, travel, tooling and control options confirmed in writing.

Assembly, wiring and a test cut on your part before shipment.

Export packing, documentation and on-site commissioning support.

Operator training, spare parts and remote diagnostics after the sale.
TECHNICAL DATA SHEET
Series datasheet · PDF, 1 page
Tell us where to send follow-up questions and the PDF opens immediately. No newsletter, nothing shared.
Used to follow up on this request only. See our privacy policy.