CNCFACT Machine Tools

CASE STUDY Automotive

Steering knuckles, 4 per cycle on a VMC

An aluminium steering knuckle that used to need two setups now leaves one vertical machining centre complete, with hole position held across the batch.

The customer was machining this knuckle on two separate fixtures — one for the mounting face, one for the bearing bore — and re-datuming between them. Hole position drifted, and every batch needed a manual check on the CMM.

We proposed a single fixture holding four parts on a tombstone, with the bore and the mounting face machined in the same cycle. Tooling was kept to eight cutters, all in the standard magazine, so no special tooling order was needed.

After the trial cut the shop ran 40 parts and measured every one. Bore-to-face position stayed inside 0.02 mm, and the second operation disappeared from the routing. The customer has since ordered two more machines for the same cell.

← All customer cases