CNCFACT Machine Tools

CASE STUDY Automotive

Piston rods turned and milled without a second setup

A 420 mm hydraulic piston rod that used to travel between a lathe and a mill now comes off a turn-mill centre complete, thread and flats included.

The rod needed turning, a thread at one end, two milled flats and a cross hole. Moving it from the lathe to the mill meant a second clamping and a runout check on every part.

The turn-mill centre does all of it in one clamping: the Y-axis handles the flats, and the cross hole is drilled from the turret before the part is cut off. Runout is set by the chuck, so the check moved to one part per hour.

Cycle time went from 41 to 26 minutes, and the lathe that used to do the roughing now runs a second family of parts.

← All customer cases