Mould & die
Flange plates drilled in one hit, eight at a time
Eight steel flanges with six bolt holes each, drilled and countersunk in a single cycle on a vertical drilling machine.
Read caseCASE STUDY Mould & die
Hardened die inserts that used to be ground after milling now come off the machine with the parting line inside tolerance.
Cutting hardened steel at 48 HRC is slow, and the shop used to leave 0.3 mm on the parting line for a fitter to grind afterwards. That step depended on one person.
With a small step-over and a constant cutting load, the finishing pass now goes straight to size. The inserts are checked on the CMM and go to assembly without hand work.
The parting line holds at 0.02 mm, and the fitter who used to spend two days per set is now doing assembly and tryout instead.
TECHNICAL DATA SHEET
Series datasheet · PDF, 1 page
Tell us where to send follow-up questions and the PDF opens immediately. No newsletter, nothing shared.
Used to follow up on this request only. See our privacy policy.