Inside our assembly line: from casting to test cut
Every CNCfact machine passes the same five stages before it is packed. Here is what happens between the casting arriving and the crate leaving.
Read articleTag
4 articles
Every CNCfact machine passes the same five stages before it is packed. Here is what happens between the casting arriving and the crate leaving.
Read articleThin walls move after the cut, not during it. The fix is usually in the toolpath and the clamping force, not in a tighter machine specification.
Read articleA single Ra number on a drawing hides the measurement length, the cut-off filter and the direction of lay. Clarifying those three points avoids most finish disputes.
Read articleEvery machine runs a 72-hour programme before crating: geometry, thermal drift, tool-change repeatability and a full test part on your material when supplied.
Read articleTECHNICAL DATA SHEET
Series datasheet · PDF, 1 page
Tell us where to send follow-up questions and the PDF opens immediately. No newsletter, nothing shared.
Used to follow up on this request only. See our privacy policy.