CNCFACT Machine Tools

CASE STUDY Electronics

Heatsink base plates, fins machined in one pass

A 180 × 120 mm extruded heatsink base needed the fin roots cleaned and the mounting face flat within 0.05 mm — done in one clamping on a vertical mill.

The extruded profile arrives with a wavy mounting face and fins that are already close to finished width. Clamping too hard closes the fins; clamping too light lets the part lift during the face cut.

We used a low-pressure fixture with four soft jaws on the base only, and cut the mounting face in two light passes rather than one heavy pass. The fin roots were cleaned with a 6 mm cutter at a shallow depth so the fins kept their section.

Flatness stayed inside 0.04 mm across 6,000 parts per month, and the shop no longer needs a separate lapping step before assembly.

Part parameters

Item Specification Tolerance Check
Part size 180 × 120 × 22 mm ±0.2 mm Every part
Base flatness 0.04 mm over full face 0.05 mm max 1 in 20
Fin pitch 4.0 mm, section 1.2 mm ±0.05 mm First article
Mounting holes 4 × M6, position from datum A/B ±0.1 mm Every part (gauge)
Surface finish Ra 1.6 on base face Ra 1.6 max 1 in 50
Cycle time 3 min 40 s per part — Per batch

Why it works

The two light passes on the base face are what hold the flatness. One heavy pass pushed the part off the fixture and the fins closed up; splitting the cut keeps the clamping load low and lets the extrusion relax between passes.

← All customer cases