Electronics
Heatsink base plates, fins machined in one pass
A 180 × 120 mm extruded heatsink base needed the fin roots cleaned and the mounting face flat within 0.05 mm — done in one clamping on a vertical mill.
Read case
Electronics
A 180 × 120 mm extruded heatsink base needed the fin roots cleaned and the mounting face flat within 0.05 mm — done in one clamping on a vertical mill.
Read case
Electronics
Small aluminium connector shells with three bores each — 24 parts on one plate, tapped in the same cycle.
Read case
Electronics
Thin-walled aluminium frames with 46 tapped holes each — run on a compact drilling and tapping centre with a repeatable fixture and a fast tool change.
Read caseTECHNICAL DATA SHEET
Series datasheet · PDF, 1 page
Tell us where to send follow-up questions and the PDF opens immediately. No newsletter, nothing shared.
Used to follow up on this request only. See our privacy policy.