CNCFACT Machine Tools

CASE STUDY Electronics

Connector shells, 24 parts per cycle

Small aluminium connector shells with three bores each — 24 parts on one plate, tapped in the same cycle.

Each shell is 26 mm long and carries three bores plus one M3 thread. Handling 24 loose parts per cycle by hand was the bottleneck, not the cutting.

The fixture is a single plate with 24 nests, loaded outside the machine while the previous plate is cut. Bore and thread are done in the same cycle with a rigid tap, so the parts come off ready for anodising.

The cell now runs 40,000 parts a month with one operator looking after two machines, and the thread-call rate is checked on four parts per plate rather than every part.

← All customer cases