CNCFACT Machine Tools

CASE STUDY Mould & die

Flange plates drilled in one hit, eight at a time

Eight steel flanges with six bolt holes each, drilled and countersunk in a single cycle on a vertical drilling machine.

These flanges are plain parts, but there are a lot of them and every hole has to line up with the mating pipe. Radial drilling one hole at a time was both slow and inconsistent.

The machine is set up with a four-spindle head and a fixture holding eight flanges. Two indexes cover all six holes plus the countersink, with the positions taken from the fixture rather than from a marked-out plate.

Hole position now holds at ±0.1 mm, and the shop runs 1,200 flanges a month in the time it used to take for 700.

← All customer cases