CNCFACT Machine Tools

Surface finish: reading Ra values on a shop drawing

Ra is an average, so the same number can describe a smooth surface with one deep scratch or a uniformly rough one. The inspection method matters as much as the value.

Three questions to ask

Which cut-off length was used? Which direction relative to the lay? Is the value a maximum or a typical? Without answers, two labs can measure the same part and disagree by 30 percent.

Set the process, not just the spec

Specify the finishing operation and the tool radius, then confirm with a first-article report. That gives the shop a process window instead of a single pass-fail number.

Our first-article reports include the measured trace, not only the result.